Service

We take the word „service“ seriously. For us this term is not only a modern phrase, but it is our philosophy. We are convinced that only by the combination of high quality simulation with customer-oriented advisory service, the most efficient method of production can be found. We therefore offer our customers, besides the distribution of the product Moldex3D, extensive services in the area of component part and process optimisation.

By a special offer we put the full efficiency of the Moldex3D and our Know-How at the disposal of small and medium-sized companies. Our goal is to increase your competitiveness. For that no Moldex3D full licence must be applied for, as on the basis of the data of your CAD-geometry and additional process parameters, we will analyse the problem for you – project-related and in direct contact with you. We will present our results on the spot, work out solution possibilities and discuss further steps.

In case the analysis and discussion with you shall result in the fact that essential modifications are necessary at the component part, then we shall offer you the full spectrum of performances of an engineering office, in cooperation with our experienced partner Impetus Plastic Engineering GmbH, from the conception over constructions to the structure mechanical design of component parts.